Note 1: This repeatability is ensured at an ambient temperature of 20°C.
Note 2: Maximum load capacity guideline is determined based on rated revolution of the motor at the acceleration of 0.3G.
The motor capacity assumes the use of an AC servomotor. Values are guidelines when using 1/5 reducers.
Note 3: The static permissible load is determined by the bolt joint strength, and the static rated load of the LM guide unit, ball screw unit and the support bearing.
For safety purposes, please take into consideration that the strength of the actuator mounting unit is not included.
Note 4: The static permissible moment is the maximum value of the moment in each direction.
U1: inner dia 38.1 mm,
M4 depth 8, mounting pitch 47.14 mm(NEMA23 Standard)
124:Â Â
1240 mm(Stroke: 966 mm)
142:Â Â
1420 mm(Stroke:1146 mm)
160: 1600 mm(Stroke: 1326
mm)
178: 1780 mm(Stroke: 1506 mm)
196: 1960 mm(Stroke: 1686 mm)
Model
Base length
LM guide typeÂ
Belt driven
End plate type (for motor mount)
Cover
Sensor*1
Cable carrier
Mounting hole
GL20N
-
124
-
HV
-
EH
-
V1
-
C
-
N
-
N
-
Y
GL20N
070:Â Â
70 mm(Stroke: 400 mm)
HV:Model SHS-V
EH:Â Belt driven
B1: inner dia 50 mm, 5.5 thru, PCD60 mm
C: With cover
N: None
N: None
Y: Standard counterbore holes
082:Â Â
820 mm(Stroke: 520 mm)
B2: inner dia 60 mm, 6.5 thru, PCD90 mm
106:Â Â
1060 mm(Stroke: 760 mm)
U1: inner dia 38.1 mm,
M4 depth 8, mounting pitch 47.14 mm(NEMA23 Standard)
124:Â Â
1240 mm(Stroke: 940 mm)
V1: inner dia 73.03 mm,
M5 depth 10, mounting pitch 69.6 mm(NEMA34 Standard)
142:Â Â
1420 mm(Stroke:1120 mm)
160: 1600 mm(Stroke: 1270
mm)
178: 1780 mm(Stroke:1450mm)
196: 1960 mm(Stroke: 1630 mm)
Note 1: Sensors can be purchased separately here
The above selections are
Online Store standards. If you need a
selection that differs from the standard, please contact us at [email protected]